djg

Black pack windscreen surround and stanchions. Glass badly damaged requires new. Good condition. £100 + p+p.

Thanks Ray. Found it and purchased.

I'm looking for a Clayton fresh air heater as fitted late 90s. Embossed 7 on the casing. Many thanks in advance

Does this fit in the tillets? If so I'd like it please. Thanks Doug

Hi. Are these still available?

Seeing as eu2 engines are getting scarce has anyone swapped a standard Ecu eu2 engine to eu3 engine and ecu setup? Is it simply remove engine, associated loom and ecu and then replace with an eu3 setup? Or is there a lot more to it. TIA

Ntdwm This just popped up on FB market place in Wallingford Oxon. https://www.facebook.com/marketplace/item/542083976305009/

First question is are the rear brake lines solid or flexible onto the calipers? if they are solid then the problem maybe that the calliper is now sitting further over due to the brake line being set up for the older calliper size, and therefore the outer pad can float in the space. Just my thoughts.

I have a ford diff c/w lsd fitted in a 96 super light with de Dion and the ratio is stamped on the horizontal flat face just behind the nose. If you get under the car and diff and look at it just clean the flat faces and it could well be there.

If you after a plain black silicone hose then Classic silicone hoses do a Caterham 7 K series kit. Doug

On my k with dry dump if I remove the starter some times I have to slacken off the starter bolts a bit then start the car. Stop the engine and tighten the bolts. The starter doesn't always align nicely and just needs encouragement to fit. hope that helps Doug

Hi If u can locate it and its still reasonably serviceable I would be interested. I will message u once home tonight. Doug

Hi Barkalarr i only have my old 6 speed one, it has all fallen apart. I like it so am seeing if there are any out there. Thanks anyway.

I am looking for an original 6 speed leather gear knob for a 1997 car.. Thanks in advance? Doug

Hi Tim I would like the pump. Doug

Saw you in the traffic Between junc 10 and 11 west bound 4.30 pm Fri 26th.

Photo to follow when I can get to the garage. The bottom rad hose is different for a dry sump. It goes straight back from the rad for about 50 mm then does a 90 degree turn straight up then turns back towards the engine again. It joins the steel pipe here. The steel pipe then only just clears the pulley by going over the top of the pulley and pump assembly. The steel pipe has a flattened side to allow it to clear the pulley. Hope that helps. Doug

Located in Lambourn, between Junc 14 and 15 of the M4

Toyota Yaris SR D-4D 5 door. 2007 '57 Plate Colour : Mettalic Vivid Blue 1.4 Diesel 5 Sp Alloy Wheels Single zone Climate Control Electric Front Windows Electric Mirrors Keyless Entry/Push button start VSC - Vehicle Stability Control ABS 60/40 split rear seat. Rear seats tilt and slide to allow space in the boot or the passenger compartment. Tax £20/yr at present Mot til Sep 15 78,000 miles Just had the 80 k service done. New battery fitted at this service. Alternator belt has a slight noise on cold start up but clears after a few moments. No dinks but a couple of minor scratches one on the passenger door and another on the rear bumper. The SR is effectively the T spirit spec with the addition of an alloy gear knob, rear spoiler and exhaust pipe trim, with subtly different alloys. My wife bought the car from new and has had it serviced at Toyota since. Photos on request £3750 ono

qwertyuiop asdfghjkl zxcvbnm Checking spacing !

Check all your the connections are tight and good as JK has said. The symptoms you are suffering are exactly as I had on mine, it turned out to be a useless connector in the main feed to the starter. I replaced it with a good brass one and now she starts fine, no throttle reqd. Doug

I ordered a Banner from 7 Speed Weds eve. Took delivery today. Doug

I have had these exact symptoms. A brise starter and a banner battery. After all the usual reset ecu, plugs etc it turned out to be the modified main starter cable. It had a carp connector in it that I replaced with a decent one. I can now start to the car with no throttle fine. Hot or cold. As u say a large volt drop caused by too much resistance. Doug

Mail received. Reply sent Doug

If the minilites are 6x 13s I would like them Can you confirm the size Doug