Go4it1011 Posted March 2, 2016 Share Posted March 2, 2016 Can anyone tell where I can get the same light. It's for the flashing red light for the immobilizer for a Rover K Series Link to comment Share on other sites More sharing options...
Steve Sheldon Posted March 2, 2016 Share Posted March 2, 2016 Link not working Link to comment Share on other sites More sharing options...
Ray Pearce Posted March 2, 2016 Share Posted March 2, 2016 Try this... http://thumbsnap.com/i/30AcnQHw.jpg?0302 Link to comment Share on other sites More sharing options...
Go4it1011 Posted March 2, 2016 Author Share Posted March 2, 2016 Thanks Link to comment Share on other sites More sharing options...
phil 01 Posted March 4, 2016 Share Posted March 4, 2016 Sterling excel 01257-249298 scorpion group, give these a tryregards phil Link to comment Share on other sites More sharing options...
Titanium7 Posted March 4, 2016 Share Posted March 4, 2016 Looks like a standard red LED to me Link to comment Share on other sites More sharing options...
cj247 Posted March 5, 2016 Share Posted March 5, 2016 I got one from Caterham a couple of years ago when I installed one as a low oil pressure warning light Link to comment Share on other sites More sharing options...
cskip Posted March 5, 2016 Share Posted March 5, 2016 what about this:http://www.vehicle-wiring-products.eu/product.php/762/led-warning-light-to-fit-8-2mm-hole Link to comment Share on other sites More sharing options...
brianmurray325hotmail.com Posted March 5, 2016 Share Posted March 5, 2016 Maplin will sort you out, no prob', you need a 12volt led although i've even used 6volt leds on 12volt systems they're hardy little beggers Link to comment Share on other sites More sharing options...
Paul Deslandes Posted March 5, 2016 Share Posted March 5, 2016 All LEDs require a series resistor to limit the current, normally for a standard small lamp about 10 - 20mA. If the LED has a specified voltage it will have a resistor included in the leads, otherwise an approx 1000 Ohm (1k) resistor should be used at 12V. Your immobilizer probably has the resistor built in internally.They are also polarity sensitive so must be connected the right way around. Link to comment Share on other sites More sharing options...
Go4it1011 Posted March 6, 2016 Author Share Posted March 6, 2016 Thanks lads for all your useful assistance.It's what being in a good club is all about!Thanks again. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now