I replaced mine with this from Burton and is great but a bit tricky calculating the spacers. I put a hole in the top of the bellhousing for bleeding pipe and made a plate up to cover the side where the arm normally goes with for tapped holes in the bell housing for caphead screws. I got custom hoses made up at Merlin Motorsport as the normal ones from Burton didn't come with a banjo connector for the girling master cyclinder I also got from Burton.
https://www.burtonpower.com/hydraulic-clutch-cylinder-nose-apc5.html
You could purchase parallels from the App Store, that will allow you to run a virtual Windows 11 machine on your MacBook.
Since Apple moved to ARM processors it is the only way as Microsoft OEM license ARM operating systems. The old boot camp methods can’t work unlike the old Intel MacBooks.
I have a new Raceco exhaust silcence to replace my Techcraft and had a custom bracket for the Techcraft.
Is this the correct bracket for mounting the Raceco? The exhaust is left hand side.
https://caterhamparts.co.uk/mounts-gaskets/1077-exhaust-mounting-bracket.html
I use serial ports a lot working in IT configuring network equipment, if you know what you are doing with a RJ45 to DB9 adapter, get an airconsole you can connect via Bluetooth or WiFi and saves being attached to a cable.
https://www.get-console.com/shop/en/27-airconsole
I would go into Device Manager on Windows and have a look under "Ports (COM & LPT)", make sure the adapter is being seen correctly. If you right click it into properties check the device status. You will also find if you use a different USB port on your laptop the COM port number will change.
Also check on the Emerald ECU you are connecting to the comm port as there are two that look the same and aren't.
Agree absolutely great day.....until my start motor went after lunch! Only upside was getting in the air conditioning sooner. The track really showed how the cars handle and now have a few thoughts about what to tweak over the winter. Look forward to doing it again at some point.
Cheers Nigel, only one way now to definitely know. I'm hoping it will reduce the noise a bit more as it a bit bigger than the techcraft one I have fitted.
Has anyone fitted a Raceco silencer to a BDR? Trying to work out if the central inlet will work rather than side inlet without a major change to the angle the primaries come out at into the 4-to-1.