Dixa1225
-
Posts
184 -
Joined
-
Last visited
Content Type
Profiles
Forums
Blogs
Events
Blatmaps
Speed Championship Results
News
Website Help
Downloads
Gallery
Store
Everything posted by Dixa1225
-
Hi Paul, I was in my car around that time but not at the BP Garage , must be someone else
-
Hi Julian That was me , wasn't sure I had the correct evening due to no Seven's in the car park I had such a good blat to the pub decided to carry on driving . Will catch up with you all next time! Regards Dean
-
Hi Rob, You have blatmail . Regards Dean
-
Thanks for your help on this
-
Ha , regarding the leak , ok at the moment but don't want to temped fate !!
-
Hi SM25T, Fan cuts in at 95 on the old switch , I have a Stack temp gauge and know it reads fine. Thanks for your help on this .
-
Just an update, swap back to the old switch with a new gasket, Fan cuts in fine .
-
Just backfilled via bleed hose by fan switch . Still no luck , Beginning to think I have a faulty fan switch
-
Hi Garybee Yes to : Is there a small hose connector
-
Hi Paul, No bleed screw on top of rad but does have a hose to a t-piece that goes to the expansion bottle , going to take this of and back fill top of the rad . Many thanks
-
The engine is a K series
-
Hi SM25T Yep , wiring fine , joined wires together and fan cut in . Rad is hot top and bottom . Any idea how to remove the airlock ?
-
Hi Elie , Yep same markings 98-93 purchased from redline
-
Replaced fan switch due to leaking on a new radiator . Fan will not cut in on new switch . Both Top & Bottom hoses are hot so does not appear to have a airlock . By passing the switch by joining the wires together kicks the fan in . Any advice appreciated
-
Hi All, Just to update this post , replaced leads & TPS and problem still remains*grumpy* . Its very intermitted with some days the car running fine ! Any further suggestions welcome.
-
Thanks for the suggestions , I am going to replace the leads & I do have a spare Throttle Position Sensor so will replace that to.
-
Nope , nor been washed
-
I have K series EU2 1.8 . I am getting a misfire under load . This can happen either hot or cold . Annoyingly this is intermittent ! Any ideas ? plugs , cap & rotor have been replaced 300 miles ago . HT Leads the next to try ?
-
Hi Erngor, You have a blat mail on this item. Regards Dean
-
Wanted 1.6 or 1.8 Standard K series Head non VCC for modification .
-
Hi Big Col You have BMail Regards Dean
-
8mm headed bolt holds the rotor arm in place , sits in a recess within the rotor arm
-
Yes Please
-
Wanted complete K series 1.8 engine .
-
Throttle cable please.