Leadership Team Midas Posted February 25, 2012 Leadership Team Share Posted February 25, 2012 I have decided to follow the wise guidance of Oilyhands and others, and have decided to dump the foam baffle. I have the photo that shows where the additional holes need to be drilled. just wanted to check - as there are no precise measurements as to where the holes should be drilled am I right in assuming that it doesn't matter where the holes are drilled so long as its roughly in the area shown on the photo? Thought I'd check before I drill!!! Link to comment Share on other sites More sharing options...
Titanium7 Posted February 25, 2012 Share Posted February 25, 2012 Don't believe it's critical but watch the drill doesn't 'snatch' Link to comment Share on other sites More sharing options...
Leadership Team Midas Posted February 25, 2012 Author Leadership Team Share Posted February 25, 2012 Thanks - I'll use a new drill Link to comment Share on other sites More sharing options...
Cookie Monster Posted February 25, 2012 Share Posted February 25, 2012 I did mine to eye IYSWIM & I did them 10mm. Def use a new/sharp drill as it's a lainiated gasket with metal in the middle. It all seems fine still re-installed a few weeks ago. Link to comment Share on other sites More sharing options...
Stationary M25 Traveller Posted February 25, 2012 Share Posted February 25, 2012 Clamp it firmly between two bits of wood and drill through the lot - just be sure where to drill !!!! Link to comment Share on other sites More sharing options...
richy Posted February 25, 2012 Share Posted February 25, 2012 Quoting Stationary M25 Traveller: Clamp it firmly between two bits of wood and drill through the lot Good advice. Richy Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now