Youds7

Mine to!

Graham, I use Tipton Garage ( Tipton St John) they have done mine the last 3 years. Mine is booked in next Monday. Not sure if they will let you hang around but they let me check the 2 advisories on mine last year up on the ramp when I came to collect it. they are used to doing Caterhams and kit cars, race cars and classics.

I have the Makita one and find it very good - already have lots of Makita kit so it was a no brainer because the bare unit was on offer at a tool fair.

I've used Tipton Garage near Ottery St Mary. Did the cam belt on my K series and I know a couple of other owners go there. They prepare and race their own cars not 7's though. May be a bit far for you though?

I replaced my ARB bushes as they seemed loose, I thought this wear. The new ones are as bad if not worse!

How obtrusive is the wording on the Motamec mirrors?

I did my Girling type 14's earlier in the year. Never refurbed a caliper before but it was easier than I thought. The hardest part was getting the pistons out. Technique for this described above. I replaced the pistons as one had a stubborn mark that I could not polish out. I did not separate the two halves of the calipers . It was a bit of a pain getting the dust cover spring clips back on though. I also got a pad fitting kit to complete the job.

The ratio is stamped on my diff.

I've seen reservoirs in the Demon Tweaks catalogue, no idea if they would fit your MC.

Jonathan says lift the nose, to expand on this raise the front as high as you can!

Alistair Westle Ali gear knob. Swirl tower to dry sump bell tank. Dip stick made from Ali strip. New pedal rubbers Graham, I live in Woodbury EX5

Have you thought about getting a reversing camera. I have seen one in a 7.

Mine is about the same as that. I was concerned about mine after checking it when I replaced the diff oil so asked them to look at it when it was having the cam belt changed, they said it was normal.

Any decent coach trimmer should be able to do something for you. Must be loads in the NW. Just a thought, have you tried swapping the drivers seat squab for the passenger one? It could be that the drivers one has had a lot more use and the foam is tired? If you find that better see if Qxted would supply you with a new foam, you could get it replaced locally or even do it yourself. I've not done a 7 but have done a few MGB seats.

Just had mine done, 1998 1.6 K Supersport. Had the water pump replaced as well as I think It was probably the original pump and belt. From reading lots about it he consensus seems to be to replace it. Got all the correct parts from Oilyhands. Very quick delivery! He also does custom cam shaft oil seals, one of mine was leaking slightly so I had them both replaced. I thought it better to do all the things that may need doing as didn't want to have to take off the belt again to do the pump or the other oil seal.