jody391
-
Posts
134 -
Joined
-
Last visited
Content Type
Profiles
Forums
Blogs
Events
Blatmaps
Speed Championship Results
News
Website Help
Downloads
Gallery
Store
Everything posted by jody391
-
Does anyone know if you can buy these before I make one?
-
All fitted and works well! seems that someone had already ran a wire but it was capped off under the dash! thanks all.
-
Does anyone have any further details of the wiring and switch used for this ability to switch between oil and water temps? Any images at all?
-
With it Being an SV isn't the chassis wider by 2"? This shot shows far less room for the 90° bends from the sand which plate.
-
Morning, I have no issues with the engine or oil pressure, but I want to address a slight kink in my K series appollo tank oil lines that bothers me. Before I buy new lines or make my own could anyone help to see if there is any installation tweaks/changes that have been found to allow a better routing of the bottom tank oil line? I may buy some line and fittings and add a 180 on the bottom line but just wanted to check if anyone has any other ideas? Jody.
-
Does anyone have any Girling calipers or the bleed nipples from them they no longer want? Jody.
-
Thanks, good to know. I have a drivers side floor but would like the passengers side doing also. 2 hours with that many rivets is bloody good going! but I also suppose they know a few tricks or two ;) Jody.
-
Don't mind as I could paint them.
-
I am after some 5 3/4 head light bowls if some one is selling any? Jody.
-
I thought they were called KN's the 13"
-
How much did it cost if you dont mind sharing? and how long did it take?
-
Why would you do this? Isn't it cheating when you come to sell the car!
-
Can you post up some more images? say from the underside showing the chassis etc
-
Does any one know if its just the hole sizes that are different? Jody.
-
That is very true! if as you say the machining was poor it would only weld the mating surface. Good point!
-
It's not a friction weld, the penetration would show all over and you no longer would see the very obvious machined male/female nub. I would guess mig welded then machined off. very poorly done for sure.
-
There is probably enough deformation in the bushes when the hit occurred, and the front end squatting that its touched the body work?
-
Looks like just the weld slug to me. But the wishbone from this shot looks like it has a bend/twist? or is it the angle of the shot?
-
If you click N/A instead of a colour you can chose just 2, the thread length is however only 22mm long for the fronts? Buy Stahlbus Speed Bleeder Valve | Demon Tweeks (demon-tweeks.com) And the m10 x 1 are only 20mm in length?? Buy Stahlbus Speed Bleeder Valve | Demon Tweeks (demon-tweeks.com) If this looks correct i will purchase and give them a try. Jody.
-
But surely the threads and length wont be correct if you get all 4 the same?? Is this something you have done buddy? Jody.
-
Ok so if I am right (please check if you can anyone?) these for the front - Buy Stahlbus Speed Bleeder Valve | Demon Tweeks (demon-tweeks.com) And the rear.. M10 x 1.0 but what length?? Jody.
-
I couldn't find them, or the length required. I don't mind £30 as it's so much simpler and you get an amazing peddle so easy! but without pulling mine out I can get the correct measurements.
-
Are you sure it's a Caterham? the exhaust manifold looks very high out of the bonnet.
-
Can you change the studs without removing the hubs?
