John Vine Posted April 15 Share Posted April 15 Re the CRB, the correct one is made by INA (p/n F202994). It was designed to fit the Ford clutch fork and will fit snugly (Ford FINIS 6124270, p/n 83BB 7548 AA). The SKF one that CC supplies will work fine but tends to be a little sloppy on the fork. The INA part is not so easy to find these days but there are alternatives (such as LuK). The O-ring for the selector shaft only applies to the 6-speed box (no gasket). Agree about the washer tube for the pivot pin. IIRC, the original sleeve was rubber. Personally, I'd try Redline for the lot. JV 1 Link to comment Share on other sites More sharing options...
Skipper555 Posted April 15 Author Share Posted April 15 Thanks for the recommendations, much appreciated. I'll take a look at them. Looking at what's fallen off it does seem to bit of old washer fluid pipe. I'll see what I have in my garage. Link to comment Share on other sites More sharing options...
Skipper555 Posted April 24 Author Share Posted April 24 Still putting it all back together, but I found it interesting that the LuK CRB I ordered is actually the same SKF one that I'm replacing.... Link to comment Share on other sites More sharing options...
John Vine Posted April 25 Share Posted April 25 14 hours ago, Skipper555 said: Still putting it all back together, but I found it interesting that the LuK CRB I ordered is actually the same SKF one that I'm replacing.... Interesting! Thanks for the update. JV 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now