Gulfb Posted April 14, 2009 Share Posted April 14, 2009 R500 K Once warm but very quickly clutch seems to grab/not release with revs held between changes. Will not then select geras cleanly. Any ideas? If it is the clutch not releasing is this a simple diy? Link to comment Share on other sites More sharing options...
Mark Durrant Posted April 14, 2009 Share Posted April 14, 2009 The clutch fork could be cracked and this is not unknown on a dry sump K series engine. Check the clutch cable adjustment and if you adjust it up and the problem returns it is probably the clutch fork. Alternatively it could be the failure of the pressure plate and unfortunately it is engine out for both. Mark D Comp Sec Link to comment Share on other sites More sharing options...
Gulfb Posted April 14, 2009 Author Share Posted April 14, 2009 Mark, Thank you (once again!!) All the best - Andrew. Link to comment Share on other sites More sharing options...
The Pikey Posted April 14, 2009 Share Posted April 14, 2009 I had the exact same problem and it was a bent (not cracked) clutch fork. Took me forever to find it as it looked "factory bent" jason Link to comment Share on other sites More sharing options...
Johnty Lyons Posted April 14, 2009 Share Posted April 14, 2009 Other suspect is failing Spigot bearing Again it's an engine out job jj N.I. L7C AR 🙆🏻 Membership No.3927. 240BHP 1900cc K Series 40th Anniversary Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now