fordy

still looking for a set of throttle bodies and a set of Piper 285 or 1444 cams (or similar) for VVC.

Thanks Tom but looks like they sold very quickly

@PROBE2 your mailbox is full

@PROBE2 (Paul), your mailbox is full and I cannot respond to your BM. Thanks. Carl

Hi folks, I'm looking to get into some K series engine upgrades over the winter. Looking for interesting bits like a set of throttle bodies, ported head and hot cams, that sort of thing to marry with a Scholar 1.9 bottom end. thanks in advance. Carl.

pm sent

pm sent

It's a bit pricey that but it appears to be the only one available right now. Years ago I bought an allegedly rebuilt 6 speed box with only a couple of subsequent races under its belt that quickly needed some synchro's replacing by R&RT. I did the same again last year, with a similar story, for my current car but having learned a lesson took it straight to R&RT for a cautionary check over and it needed a couple of synchro's. Even then, all in, quite a bit less than this one.

Sold

For sale is a pair of genuine Caterham carbon front wings. These are an older diagonal weave and 15/16". Probably 20 years old now although they have never been used on a car. I was given them many years ago with some bonded in titanium wingstays, an unfinished project. I cut those back out but one of them sustained a cut about an inch long through the top coat which was subsequently repaired with a carbon repair kit. Its still visible but otherwise they are in decent condition having only sustained the odd mark from an extended period of storage. No longer available in this larger size but would be well over 600 quid from Caterham these days! I'm looking for £250 delivered in the UK.

Andrew, I'm just converting my car as you know from EU2 1.6K to EU2 1.8 VVC. I ran into the inertia switch issue as you described above and can clarify a few things here for posterity. On my 1997 EU2 1.6 K the inertia switch wiring is in the engine loom between the big grey plug and the MFRU (fuel pump relay). It changed with the introduction in 1998 of the VVC engine and is not on my 1998 VVC engine loom. Also confirmed off another 1998 car. Caterham moved the switch to the vehicle side of the big grey plug and the fuse box (fuel pump). As it stands my car may start without the switch in circuit since it's closed circuit in that yellow/green wire now and without the switch in either my vehicle or engine loom! I probably should splice a sub loom in though for safety sake and I may do it off the back of the MFRU since it's sat 4 inches away from the switch. Can anyone see any issues with that strategy?

A lot of discussion about that auction in the other place suggesting its not really an SS. Just a bitsa built up from a new chassis.

Sorted now, thanks.

I'm looking for an Aluminium guard that goes around the catalyst on systems where that is a separate part. Second hand or guided to a supplier. Out of stock at Caterham for a long time. thanks

I have 2 complete K series manifold and cat/silencer systems available. They are standard type with the 4-1 manifold inside the engine bay.