GaryK Posted March 29 Share Posted March 29 Anyone got one of these? Ital PCD 13 x 6J ET16 Any condition considered as long as it's straight. Thanks. Gary Link to comment Share on other sites More sharing options...
Area Representative manningpaul Posted April 8 Area Representative Share Posted April 8 Hi Gary, I have some 4 spoke revolutions, without tyres, which I would be happy to split. I think they might be 14's though? Will measure when i get home tonight and let you know. regards Paul. On 29/03/2024 at 13:21, GaryK said: Anyone got one of these? Ital PCDl 13 x 6J ET16 Any condition considered as long as it's straight. Thanks. Gary Link to comment Share on other sites More sharing options...
GaryK Posted April 9 Author Share Posted April 9 OK, thanks Paul. Link to comment Share on other sites More sharing options...
Area Representative manningpaul Posted April 11 Area Representative Share Posted April 11 Sorry for the delay, I have a set of five so happy to let one go, they are 13's, presumably Ital PCD as it is around 90 something and will check what the offset is tomorrow evening. Been frantically ripping out a kitchen as the plasterer starts Monday!! Link to comment Share on other sites More sharing options...
Wrightpayne Posted April 12 Share Posted April 12 Ital is 3.75” or 95.25mm PCD 1 Link to comment Share on other sites More sharing options...
GaryK Posted April 12 Author Share Posted April 12 Thanks Paul, no rush when you have time. Link to comment Share on other sites More sharing options...
Area Representative manningpaul Posted April 17 Area Representative Share Posted April 17 95.25 would seem to be right😁. Will measure offset tomorrow when home as up at Guys Hospital all day. We might eventually get there? Regards Paul. 1 Link to comment Share on other sites More sharing options...
Area Representative manningpaul Posted April 18 Area Representative Share Posted April 18 Measured offset as probably -15 but probably -16 as don't have my specs handy. Based just outside Devizes. Regards Paul. Link to comment Share on other sites More sharing options...
GaryK Posted April 18 Author Share Posted April 18 (edited) Hi Paul Am happy to take one off you. I'll pm you my email address if you could send me a picture that would be helpful. Thanks Gary Edited April 19 by GaryK Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now