150SV Posted October 27, 2023 Share Posted October 27, 2023 (edited) As above please…. only Need to take scuttle off for access to wiring behind as have electrical issue. can’t find anything on the net showing which rivets need drilling . TIA. Edited October 27, 2023 by 150SV Link to comment Share on other sites More sharing options...
JP Posted October 27, 2023 Share Posted October 27, 2023 (edited) You will need to drill the rivets that run around the front section where it meets the vertical bulkhead panel. You may need to remove the windscreen if you can't get to the screws that pass through the 2 scuttle top popper bases for the tonneau - hopefully not. Then undo the 4 nuts (2 each side) that hold the scuttle on to the side rails. Don't forget to disconnect the heated screen. Consider going to rivnuts in place of rivets when refitting. Maybe these pictures help: Edited October 27, 2023 by JP Link to comment Share on other sites More sharing options...
prisoner7 Posted October 27, 2023 Share Posted October 27, 2023 Look at the following link...go to about the 8 minute mark and this should help... Caterham 420R Build - Handbrake, Gear lever, Catch Can, Expansion Bottle & Scuttle - Episode 6 Hope this helps. Link to comment Share on other sites More sharing options...
Dan R Posted October 27, 2023 Share Posted October 27, 2023 Let me know if you need a hand..... always happy to come over and help! 1 Link to comment Share on other sites More sharing options...
150SV Posted October 28, 2023 Author Share Posted October 28, 2023 12 hours ago, prisoner7 said: Look at the following link...go to about the 8 minute mark and this should help... Caterham 420R Build - Handbrake, Gear lever, Catch Can, Expansion Bottle & Scuttle - Episode 6 Hope this helps. Brilliant, very helpfull.... Thanks for posting. Link to comment Share on other sites More sharing options...
150SV Posted October 28, 2023 Author Share Posted October 28, 2023 Am I correct in thinking, that if I have the quick release channels fitted, I shouldnt need to remove the knee panels ? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now