Duratec and Stack Gauges/Sensors

[boss351]

I am looking to replace the Caterham gauges for coolent temp and oil pressure with some Stack gauges, they come with 1/8" NPT sensor fittings. Are these what Duratec's have or will I need some x-overs?

 

Also, on a side note, has anyone switched from the Caterham petrol gauge to a Stack one? Are they compatible with the sender?

[Miltec]

I've done the same, have mechanical oil pressure, water temp and fuel gauge.

 

The only pain was configuring the fuel gauge, you have to press a button when it's empty then fill it up and press it again without powering down the gauge. took a bit to get it right but all good now 🥰

 

VX 1600 Live Axle

T440LKK

[tweeky]

Miltec........... What fuel gauge did you use (Stack model) ive dont the oil pressure gauge just thinking of the other two this year.

 

Tweeky

 

to infirmity.................... and beyond

[Mcalvert]

Word of warning when calibrating the Stack fuel gauge. Don't whatever happens drain the fuel to a minimum to set the "empty" level, set off for to the fuel station to register the "full" level but get tempted to "just go for a quick spin " first instead.

 

Having to call your wife to come out with a jerry can to get you going again is very embarrassing

 

Michael.

 

Edited by - Mcalvert on 20 Jan 2011 14:44:47

[Miltec]

Stack Page here

 

I have the following 🥰 all with full sweep on the gauge rather than the 90deg you get on the normal ones

Water Temp ST3307

Oil Pressure ST3101

Fuel Level ST3315

 

Very easy to fit

 

VX 1600 Live Axle

T440LKK