gwiddicombe

Thanks for all the replies. Willie, yes the indicator does go higher when I rev it harder. It's never really gone above about 4, but it continues to do that at higher revs My Caterham Build Diary available here

I know from reading on here that the standard oil pressure goes faulty on occasion. I have a Rover 1.6 K with about 5800 miles on the clock. I took the car for a spin today and noticed that the oil pressure is reading lower than normal at idle. It normally reads about 2 bar at idle and has done since new. Today at idle, whilst standing at the lights after a drive I noticed that it was reading about 1.5bar at idle. The warning level on the dial is between about 0 and 1 bar. If I rev it to about 1300-1500rpm it goes to the usual 2 bar. The levels seem okay and it's not leaking oil as far as can tell. Should I be worried? My reason for this post is that I'm on the WightBlat next weekend but haven't really got time before then to fit a new sender. My Caterham Build Diary available here

Whilst I was eating me cornflakes, it occurred to me. Is it due to the fact that although the filament doesn't appear to be blown, it probably is? Because the bulb is a double filament one, when I put the bulb in the other way around the filament that isn't broke lights up? My Caterham Build Diary available here

Forgive the stupid question... 😳 On my 2008 Rover Caterham, I've had the drivers side rear brake light go twice. When I've come to replace it, on both occasions the filament doesn't appear to have blown. The bulb itself can only go in one way round due to the pins, but again on both occasions if I try the bulb in the other way to make a connection, the bulb lights up[1]. If I replace with a new bulb, it lasts ok certainly for a few weeks. Any ideas 🤔 [1] I haven't explained that very well, but for the avoidance of doubt, I don't mean that I'm trying to put the bulb in upside down 😬 My Caterham Build Diary available here

Good point....I'll do that. Thanks. My Caterham Build Diary available here

OK - thanks. I've just ordered one from Caterham, and I'll look into providing a stop too. My Caterham Build Diary available here

My car has been on the road since the end of July 08 and has covered about 4500 miles. The clutch cable snapped today, resulting in me having to call out the AA The AA chap fixed the cable with a grub screw, but I need to get it replaced with a proper item. Can someone point me in the direction of where to get one from, or is the Caterham one the best one to get? I'm not sure why the cable snapped, but it failed at the pedal end, right by the cable eye. Last time I checked it (a couple of months ago) there was 'play' in the eye which meant I could move it easily. However, today the AA guy had to forcibly prise the eye out with a pair of pliers/pinchers, which I'm guessing is what caused it snap. My Caterham Build Diary available here

OK - thanks all. I hoped it was something like that, but thought I'd check here. My Caterham Build Diary available here

My car (1.6K Series, De Dion, standard brakes, 08 plate) has recently started developing a problem in that the rear wheels are locked when I drive away after the car has been left for a few days. I may have only just noticed the issue as the car is not used daily at the moment, whereas it was up until a month or so ago. When I say 'the rear wheels are locked', I mean that they are locked slightly when I very first pull away so that it is noticeable, but are then immediately okay. The car is garaged over night and left with the handbrake on. Is this something to worry about, or is it just one of those things? Cheers, G My Caterham Build Diary available here

Thanks all. I've ordered the Optimate...hopefully it''ll do the job. My Caterham Build Diary available here

Hi, I'm looking to purchase a battery conditioner, and there are a few on e-bay and from searchin on here the Optimate 4 appears one of the ones to look out for. I just wanted to check that this is okay. Does this seem genuine? There are loads on there around this price - it's a 'tecmate' Optimate 4. My Caterham Build Diary available here

I'm probably getting the terminology wrong here, hence no luck with a search. Where do people buy their front number plate "stickers" that they stick to the nose cone? What I mean is, rather than using a traditional number plate, some cars have the regsitration number on a sticker that is attached to the nose cone. I hope that makes sense.... My Caterham Build Diary available here

OK - I was hoping this would be a simple fix. I called Caterham up and they sent me a new plug and washer. Fitted them this evening, but the thing is still leaking Any other ideas? The leak is definately coming from the plug, but the new parts haven't cured it. I'm hoping it's not the sump that has cracked near the bolt. Could it have been overtightened after it had been serviced? How would I prove it if this is the case. I don't really want to go to the expense of a new sump incase that doesn't solver the problem.... G My Caterham Build Diary available here

Must Type Faster - I think (I had to Google it though)?? 😶‍🌫️ My Caterham Build Diary available here

RJ - do you the size of the plug? Where do you get the VW ones from, or do you go into a dealer? Had a quick look at Halfords website and they have different sizes, but no specific VW ones it seems. My Caterham Build Diary available here