Scotland North AR Posted May 2, 2018 Share Posted May 2, 2018 Hi, I've just found one of my front wheel bearings goosed, the hub has worn to such an extent that the outer race of one bearing spins in the hub and can be moved in and out by finger.I have a new shaft, hub and bearings but a thin washer in the pack of bits I don't think was on the car when I took it to bits. It is about 1.5mm thick, the same inside diameter as the shaft i.e. 25 mm. Am I right in assuming it should go against the upright on the outside before the hub goes on, then the thick spacer then the wheel bearing nut?The thin washer resting on the split pin is the one in question.Thanks for any assistance. Link to comment Share on other sites More sharing options...
Tazio Posted May 2, 2018 Share Posted May 2, 2018 Yes it goes on the stub axle next to the upright, the fat washer goes under the castellated nut.Alan Link to comment Share on other sites More sharing options...
Scotland North AR Posted May 3, 2018 Author Share Posted May 3, 2018 Thanks for that Alan, just waiting for a new rubber boot for the top ball joint and will then reassemble. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now