Ant m

Guy came through on that email address you gave me, thanks for the help. Heres the drawings in case anyone else needs them. 0900107 Stack Oil and Water Temp Leads.pdf 0900105 R300 - 500 Race Engine Harness.pdf 37L049C New Race Chassis Harness.pdf

Yes its the same enquiry, i have the STD diagrams in the build catalogue but it is slightly different. Thanks for the info and email ill see if i get anywhere with that. Thanks.

Hi, please can someone help with the following: I have a caterham 420 race factory race loom and engine loom, i need the diagrams for these please so i can add the additional wiring required to put this on the road. They are the Caterham part numbers: https://caterhamparts.co.uk/looms/6194-engine-loom-420-race-car.html https://caterhamparts.co.uk/looms/3827-engine-loom-road-08-r300-a-r500-duratec.html These are the looms i have, but the 420 built manual i have shows different interface connectors so i was hoping someone would have the diagrams for these please to make it easier to see what i have and what is missing and where to take powere from etc. I am also running a stack dash, i have a good sparky on it but obviosuly diagrams will make the whole process alot easier. Appreciate any help with this, thanks ,Ant.

Unfortunately not, I need a new unit for the project car.

Hi, can anyone advise of a duratec alternator that doesn’t cost the earth? thanks

Thanks for this, I have now sourced, coil, injector, fuel tank and alternator sub loom. Luckily have helP from a competent sparky but trying to make it as easy as possible. Yeah it’s quite a lot of work, the mechanicals don’t both me too much. Just need to knuckle down. 😳

Superstar, thanks for that. 👍👍

Thanks for the additional feedback, so the car is an old palmer car, originally k series and converted to duratec on LPG, had a cosworth ecu etc. I have started restoring this and converting back to fuel. I was provided some std caterham looms but with no info unfortunately and these had the original ECU connection, I have been sourcing the original sub looms etc bit by bit, I found the R300 ECU online and have been buying parts to return this to STD. I should be able to get this ECU unlocked when needed but I want something plug and play to get me started as I have enough work to do as it is. Off to the Fab shop tomorrow for some repairs etc… the bags for the looms had the following numbers but that’s it: 37LO49C - 37LO50B. not sure what these mean, hopefully someone on here does??

Thanks for the help, I’ll have a look through the diagrams. If I find out anything useful I’ll forward it on. 👍

Hi I’m after some help on wiring diagrams please, have a duratec 2.0. Currently fitted with a race loom. But want to covert to road use, I have 2 looms for the duratec engine with a stack dash. But unsure exactly what I have etc. any help would be appreciated. Thanks Ant.