MrBlanc

Steve found me one! Thank you

Good morning, can anyone tell me the length of the tube for this part listed below. I posted in wanted section and shopped online but looks like I'll need to have one machined, however, I need the length of the tube section please. Unless someone reads this and remembers they have one in the shed

Can anyone please tell me the length of the tube only on this part. Looks like I'll need to get one machined up.

Thanks, I'll contact them after the bank holiday and check all the measurements. But this is looking good so far. I tried calling QUAIFE last week but had no luck getting through. But the one at Burtons... fingers crossed.

Thanks, just looked and it's still showing as out of stock for me.

Thanks, I've not no. I can't see anything on their website but I'll give them a call on Tuesday.

Hi Ian, so was the steel sleeve pressed into the ally cap?

I'm looking for a: Caterham 6 Speed Gearbox front cover tube sleeve Caterham Part Number - 70004C Can't find stock anywhere and it's holding up the build. HELP.

The previous owner was going to use it for racing, mainly hill climbs I think. But said they soon swapped for a different option set up. I researched the Caterham 6 speed, which I think is basically a Type 9 in different casing. But hadn't appreciated the Clutch Nose can be different. But all part of the fun of the build. The previous owner said it would work with a K-Series. I may need more than the clutch nose at this rate.

Hi JV, It did come with the gearbox as a used purchase. That image looks more like it would fit the bell-housing better. I'll try Phil tomorrow. Thank you.

Yes, 6 speed and looks clean and new inside. That's about all I know. Had to role the dice on it as I needed a gearbox.

Not sure of the actual spec. It was a Facebook market place purchase. It's a standard looking Caterham case though.

Thanks Ian! That looks like a surprising cheap fix compared to what I was expecting. I'll do some research to check I get the correct one. Thanks again, and for responding so quickly. Phillip.

Hi, I'm trying to marry a K Series and a Type 9 gearbox. I'm not great with part names so I'll post photos. But the part seems to be different to what is photographed on Caterham Parts website. The shape fouls the bellhousing but also doesn't sit flush to the gearbox and leaves a minor gap. Is it the wrong part, maybe I need an adapter? Thank you for any guidance.

The engine is new so I need to upgrade the sump to a caterham one. Still looking for those also, I have some one checking if they have a dry sump and I've read that's the way to go. But I'm unsure.