coffeekid

Where are the recommended positions for the pads when lifting an S3 on a 2 post lift?

Thanks. Am I right in thinking the car takes 4.5L (it has a wet sump)

Thanks - mine just says 'Caterham Approved Oil'

About to do an oil change on my 360S - whats the recommended oil to use?

I would try sitting in an S3, I think you could be surprised.  

I had a 997.1 C2S - now have a 981 Boxster in it place and much prefer the drive of the 981 

Thanks guys 

2017 and just standard

Can anyone send me a link to the correct discs and pads I need for a 360S?

thanks 

Battery providing enough power?  

slj1 - overall what have you thought of the upgrade? - if you knew then what you know now would you do it again? Seriously considering this myself at present too. 

I have a 360S - clutch bite point is very high - almost at the limit of travel.  Given my limited knowledge I dont know if this is normal or not?

Yup. I have one spare - bought one, went to fit it and found there already a connection on my car. Still brand new in the packaging.  I'll have a look for it in the garage tomorrow 

Thanks

I see millers now list this as the replacement for the xfs - is this the stuff to go for?

https://www.opieoils.co.uk/p-60214-millers-oils-xf-longlife-5w-50-full-synthetic-engine-oil-formerly-xfs.aspx

Is there a complete list of parts anywhere that I need in order to do an oil service on my 360S?

What oil filter? What oil and amount etc 

Thanks 

Haha - absolutely. Ctek conditioner already purchased. Lesson learnt 

New battery installed, sorted the problem - started first time - thanks to all who helped

So.....checked the voltages of the battery 12.42v dropping to 9.1v during cranking

Currently on the charger - hopefully that sorts it 

Car has not been used for about 2 months

Just tried to start it but to no avail.

Its a 2018 360s

When I turn ignition on I can hear fuel pump priming.  Press starter button - can hear starter motor etc trying to start but the engine doesnt fire up.

Any suggestions? (obviously the best suggestion is drive the car more often)

Thank in advance

This is the cable I have

Simple question guys...

I have just bought a CTEK MXS 5.0 to keep the battery charged during times of infrequent use of the car.

Going to permanently connect the eyelets so I just need to plug in charger each time.

Do I need to attach the negative eyelet to somewhere on the chassis or to the negative pole on the battery?

Thanks

I’ll take it.  Will PM you now

Have just double checked - it is actually green and purple  

so does that mean I don’t need the sub loom I have just ordered 

Behind drivers side rear arch, where the wires go to the rear light cluster there are 2  connectors hanging.  Black wire and green wire.  Any idea what they are for?