Carcoon - Fan details?

[Ian B]

Has anyone got the dimensions and electrical details of the fans on a Carcoon please?

 

I think they're 75mm square, 12v, 0.1amp, but would appreciate a confirmation.

 

Thanks

 

Ian - MI 5EVN - Slightly Vider SVelte model 😬 now repainted to match the Autocom headsets 😳

[Ian B]

Could also do with knowing the flow rate if they have it marked on them?

 

 

Ian - MI 5EVN - Slightly Vider SVelte model 😬 now repainted to match the Autocom headsets 😳

[Ian B]

No one got one handy to look at then? ☹️

 

 

Ian - MI 5EVN - Slightly Vider SVelte model 😬 now repainted to match the Autocom headsets 😳

[GasMan]

Hi

Mine are as follows Manufactured by Innovative, Model No: BP802512H

12V 0.2 A 80mm square.

Hope that helps.

Matthew

[MARK LE LAY]

I have replaced mine over the years. I sourced them from rs who have a large range of the fans.

 

I also modified the carcoon setup. the original ones were glued and were difficult to remove, so I ended up using a dremel and cut 3/4 of the fan off, leaving 1/4 behind still attached, this acted as a base plate for the new fan to be bolted with m4 nuts/bolts/washers through the designated fixing holes.

[Ian B]

Thanks guys

 

Mark, I don't suppose you have the RS number, to save me trawling through loads of them?

 

I'm actually looking to run this from a solar charged battery so might disconnect one, or try to find very low power ones (which, if they do exist, I suspect will only push 1/2 as much air anyway!).

 

Ian - MI 5EVN - Slightly Vider SVelte model 😬 now repainted to match the Autocom headsets 😳