Replacement stub axle part number?

[techbod]

Car '89 live axle, classic front suspension setup

Chasing down strange noises on the Caterham, I have found that the inner bearing race on the passenger side hub has spun and scored the stub axle. Can anyone confirm that the correct replacement part number should be UKC697 as linked below?

https://www.canleyclassics.com/?diagram=triumph-spitfire-mki/ii-front-suspension&ptno=UKC697

Thanks

 

[TomB]

Give Chris Mintoft aka Mr Redline a ring, bet he’ll have it in stock. 

[Richard Price]

Can anyone confirm that the correct replacement part number should be UKC697 as linked below?

yes. That is the correct part. 

[Wrightpayne]

I helped Tazio change a couple of these as I have a 1T arbor press. Needed a tube on the lever and came out with a bang, like a gun going off.

If doing again I think I'd apply some heat to the casting with a hot air paint stripper.

Regards

Ian

[7 wonders of the world]

Morse tapers respond better to a shock to release as opposed to an increasing load with a press.

Firmly support the upright with the stub free from the ground, place nut on rear face about 1 turn from fully home.

Apply very sharp blow with 2lb knocking stick... and out it pops, remove nut and your done.

[techbod]

Thanks very much for the replies and helpful advice.

Its much appreciated.