R500 Superlight Aluminium Brake test switch wiring (RESOLVED)

[Token Jock]

Hopefully somebody can help me out

My brake test switch on my R500 (aluminium Savage push button switch was a bit sticky and in the process of fixing it I stupidly removed the wires without noting which terminals they were connected to

There are 5 terminals at the back of the switch, a row of 3 and a row of 2.

I have a black wire, a green wire, a white & black stripe which loops into a black & white stripe wire

Are there any fellow Blatchatters that would be kind enough to stick their head under their dash and to check how their brake test switch is wired?

Thanks

John

 

[Jonathan Kay]

Would you like the whole diagram?

Jonathan

[Token Jock]

Great thanks JK

The whole diagram would be really helpful, i'll send you a PM, i'd be very grateful if you could email me the diagram.

Thanks

John

[Token Jock]

Managed to get it sorted [smile]

So if anybody else has the same problem here was what I did.

Row of 3 pins are 1,2 3 and Row of 2 pins are A & B

Pin 1 was  +12v feed when ignition on (green wire for me)

Pin A was Earth (black wire)

Pin 2 was the master cylinder reservoir switch (Black wire with white stripe) and (White wire with black stripe)

Pin B was the looped out (White wire with black stripe) from Pin 2

Pin 3 remains unconnected.

 

I found this image of the switch terminals which was certainly of help.

Hope it helps others

John