Toad powerkey guide

[phil 01]

Good morning does anybody have a copy of the toad user instruction/guide? As fitted to the R300 I believe its the powerkey alarm, red light on dash and small proximity sensor. I may also require installation instructions if I need to replace the sensor

 

Thanks phil

[classic1952]

These are the programming instructions in case they are any help:

 

Toad programming instructions

 

04 October 2012

17:47

 

1. Remove the transponder from the ignition key ring

2. Disarm the system using an existing transponder tag

3. Switch the ignition on and off twice and then turn the key back on,all within 7 seconds. The LED will flash rapidly to indicate the system is now in programmed mode

4. Pass a new transponder close to the ignition barrel

5. The LED will flash once to indicate that the new transponder tag is in the memory

6. Pass any additional transponder tags close to the ignition barrel

7. For each transponder tag programmed into the system the LED will flash a number of times to indicate how many transponder tags are programmed into the system

8. When you have finished,switch the ignition off and the powerkey will exit the programme mode

9. Each time you programme a new transponder tag into the system it will automatically erase all other transponder tags in the memory, so all the transponder tags required to operate the system must be programmed back in.