Jump to content
Click here if you are having website access problems ×

Stalling - ECU reset


dickbowyer

Recommended Posts

Coming up to junction, the engine frequently stalls 🙆🏻. I gather this can often be rectified by resetting the ECU. Ignition on, blip the throttle 5 times and then turn off? Is is just a blip or are progressive high revs needed?

 

Dick

Superlight SV Duratec R400

Link to comment
Share on other sites

You must either disconnect the ECU from the 12volt supply, by turning the cutoff switch off or disconnecting the battery.

You can also reset the by switching the ignition on and off several times, leaving in the off position a few seconds each time.

Make sure that whenever you start the engine that the throttle pedal is not touched because the ECU will adjust to a different throttle site.

 

Mick

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...