Anyone had problems making a K3 Emerald talk to a 5AS?

[Mr Locust]

Or is it just me?

 

Computer says it is learning the code but then it just stays immobilised when restarted. I am following the instructions from the M3D controller rather than K3 as the K3 book doesn't mention this. Is there a trick that I am missing?

 

Ian

 

Green and Silver Roadsport 😬

[mav]

Have you made up a loom or did you buy one? I'm pretty sure Myles had to change the position o fthe Immopb. pin on the connector to make his work properly...

[Andy Best]

Yes I had a problem, after talking to Karl at Emerald it was to do with the firmware version I was running and the date the Emerald was built. Emerald will provide an upgrade version but it must relate to your actual Emerald serial number, so I can't send you my upgrade I am afraid.

 

I had the problem with firmware version 2.4 I think from version 2.6 the problem I was having was fixed.

 

Andy

 

 

[Mr Locust]

Mav,

 

made my own. Immob wire was as documented by Caterham but the tmap temp wire was somewhere completely different in the EU3 plug until I checked it out - don't know whether its a wiring diagram mistake or my car is 'special'. Didn't bother with IACV wiring either.

 

Andy,

 

was only shipped from Emerald c. 2weeks ago. Thanks for that, I'll check the firmware/serial and give Karl a ring tomorrow.

 

Ian

 

Green and Silver Roadsport 😬

[Andy Best]

Given you hav ejust got a new Emerald my comment is probably not valid then, my Emerald is several years old now.

 

Andy